Table of Contents
Advertisement
Connection cable
A 10 m connection cable is attached to the unit. To extend the cable, use the optional dedicated cable.
If several 10 m cables are connected in tandem, the power supply may be unstable due to voltage drops etc.
In case of emergency, voltage of up to 17V is to be applied to the DC 12V of the camera recorder. If the input voltage to the
unit is 8 V or less, operation becomes unstable.
Refer to the following. A twisted-pair cable must be used for the control line of the 10-pin cable. Attenuation of the coaxial
cable must be set to around –6 dB at maximum in 10 MHz.
Camera recorder side
HR10A-10P-10P (Hirose Electric)
CAM DATA (H)
CAM DATA (C)
CAM CONT (H)
CAM CONT (L)
ECU_ON
Video output
GND (Video)
Standby
+12 V (IN)
GND
Connector GND
1
Twisted pair
2
3
Twisted pair
4
5
6
7
1.5C - 2V
8
3 h/50 m or less
9
3 h/50 m or less
10
Controller side
HR10A-10P10S (Hirose Electric)
1
CAM DATA (H)
2
CAM DATA (C)
3
CAM CONT (H)
4
CAM CONT (L)
5
ECU_ON
6
Video input
GND (Video)
7
8
Standby
+12 V (IN)
9
GND
10
Connector GND
E-7
Hide quick links:
Advertisement
Table of Contents
