Setting Interval Conditions And Measuring - Epson Runsense SF-710 User Manual

SF-710/510/310 User Manual
Setting interval conditions and
measuring
Note:
By using the PC application (Run Connect), you can setup
interval conditions from your computer.
When setting up from your computer, you can also
customise your sprint and recovery intervals (SF-710
only).
"Setting the Interval Function (SF-710 only)" on
U
page 102
Operation buttons
Setting interval conditions
A
Display the measurement screen.
Press C on the time screen.
GPS positioning starts, and the measurement
screen is displayed once positioning is complete.
"Specifying a GPS (GPS Positioning)" on
U
page 29
B
Displays the Measure set. menu.
Hold down B on the measurement screen.
Measure
C
Select Mode.
Use C/D to select, and then press A.
D
Select Interval.
Use C/D to select, and then press A.
E
Select an empty setting.
Use C/D to select, and then press A.
When this is already set, select one of SETTING
01 to 03. Check the set content, and then press
A.
F
Select Edit.
Use C/D to select, and then press A.
44