Mounting The Accessories For Full Servo Operation - Canon XJ100x9.3B AF Operation Manual

1-2 Mounting the
Accessories for Full
Servo Operation
The servo demand is mounted and connected as shown in
the figure below. When mounting the various demands, refer
to the operation manual for the respective demand.
Servo module
Zoom servo demand
Focus servo demand
Demand cable
Mounting the Servo Module onto the
Lens
It is necessary to mount the servo module to the zoom and
focus couplings located in the bottom compartment of the
lens.
* (NOTE)
The same servo module is used for both zoom and focus couplings.
So, it can be mounted on either the zoom or focus coupling.
1
Before mounting a module to the lens, turn the lock
screw of the module counterclockwise until the lock
axis comes out to its a half way of length.
2
Press the module in the direction of arrow "A", so
that the key pins on the lens are inserted in the key
grooves of the module.
Bottom compartment of the lens
Coupling B
Index Line
(White Line)
Coupling A
3
Mate the coupling A of the module with the coupling
B of the lens. And then, fully push the module in the
direction of arrow "B" until it stops.
4
Finally, turn the lock screw of the module clockwise to
secure it. By using a coin, tighten firmly the lock knob.
Next, as the same procedure, install the servo module on
the other joint. It does not matter which is installed first,
either the zoom or the focus.
* (NOTE)
When mating couplings A and B, push the servo module in
completely, so that the index line (white line) on the circumference
of coupling B is entirely hidden. If index line is not completely
hidden, the servo module may fail to operate, or it may generate
abnormal acoustic noise.
Mounting the Switch Box
1
Mount the switch box to the panhandle of the tripod,
using the attached clamp.
2
Connect the switch box to the lens, using the included
cable.
E3
1 HOW TO MOUNT
Key
Groove
Key Pin
Servo Module
Lock
Lock Screw
Lock Axis
Lock Screw