Installation; Preparation - ABB VSN700 Product Manual

Installation

Qualified personnel with appropriate training and experience must perform installation of the
VSN700. Follow standard safety precautions during all procedures. Appropriate personal protection
equipment (PPE), such as safety gloves and safety glasses is recommended.
During normal operation, dangerous voltages flow through many parts of the
system, including: terminals, all I/O Modules (Inputs and Outputs) and their
circuits. All Primary and Secondary circuits can, at times, produce lethal voltages
and currents. Avoid contact with any current-carrying surfaces. Installation may
also require close proximity to high-voltage high-current wires, so proper caution
should be exercised when installing these devices.
Make sure all power is switched off before performing installation. These servicing
instructions are for use by qualified personnel only. To reduce the risk of electric
shock, do not perform any servicing other than that specified in the operating
instructions unless you are qualified to do so.

Preparation

Make sure you have the following tools and materials prior to starting installation.
Tools
Standard Electrician's Toolkit
•
Personal Protective Equipment (Gloves, Goggles, Clothing)
•
Materials and Test Equipment
Twisted-Pair RS-485 Wire (Belden#3106A or equivalent).
•
DO NOT USE CAT5/6 CABLE FOR THE RS-485 DATA WIRE.
Ethernet Cable to make Network Connection
•
Laptop Computer with Internet Browser
•
Second Ethernet Cable for Logger configuration
•
Mounting Screws and/or Brackets
•
It is also useful to know if you need to perform Asset Registration or final End-to-End Data Checks
after physical installation is complete. If so, you will need a User ID/password to log in to Aurora
Vision, and additionally you will need Administrator privileges to access the Administration tool in
Aurora Vision. See the Commissioning section for details.
VSN700 Data Logger Product Manual
- 7 -