Changing Configuration Parameters - HP T2200 XR User Manual

Table 3-2: Available Voltage Settings
UPS Model
T2200 XR NA
T2200 XR JPN
T2200 XR H NA
T2200 XR H INT'L

Changing Configuration Parameters

Refer to Figure 3-3 when changing configuration parameters.
Figure 3-3: Changing configuration parameters
To change configuration parameters:
1. Place the UPS in Configure mode by pressing the Configure button (5) until the
Configure Mode On LED (4) illuminates solid green.
When you release the Configure button, the configurable LEDs flash briefly, then the
LED associated with the current configuration illuminates.
HP Uninterruptible Power System T2200 XR Models User Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Available Settings
Utility Voltage (VAC)
110
120 (default)
127
100
208
220
230 (default)
240
1 2 3
4
5
Configuration
Parameter (LED)
On Battery ( )
Bad Battery/Low Battery (
Site Wiring Fault Indicator (
General Alarm ( )
General Alarm ( )
On Battery ( )
Bad Battery/Low Battery (
Site Wiring Fault Indicator (
)
)
)
)
3-3