Fujitsu Primergy BX600 Start Manual page 2

nInstalling the server to the rack
When installing or removing the server, please contact an
office listed in the "Contact Information".
1
Open the front and rear doors of the
rack.
2
Align rail with the length of the rack,
and temporarily fasten the rack using
screws.
�������������
������������������
������������������
3
Attach the rail to the rack.
Tighten the temporarily fastened screws from step
2.
�����������
����������
�������������
����
4
Install the chassis to the rack.
Place the chassis on the rail, slide it to the very
back and install to the rack.
������
������
�������������������
����������
������������������
�����������
������
5
Secure the chassis and rack.
When installing for the first time, be sure to slide the
chassis to the very back and secure it completely to the
rack.
6
Install a server blade or a dummy
server blade to the chassis.
Do not leave any server blade slot empty.
����������������������
����������������������
- When sliding or returning the chassis or server blade to
their original position, be careful not to pinch your fingers
and clothes. This may cause injury.
- The rack rail does not have a locking mechanism, be
careful not to drop the chassis when sliding it out.
- Do not install the BX620 S4 server blade in the BX600
S2 chassis' server blade slots 4, or 10.
Abnormal operation will occur.
- Attach the blank panels that come with the rack to
locations where no server or peripheral devices are
installed.
2
�����������