Rgb Connection - LG 47LV5500 Owner's Manual

114
MAKING CONNECTIONS

RGB Connection

Transmits the analog video signal from your PC to
the TV. Connect the PC and the TV with the D-sub
15 pin signal cable as shown in the following
illustrations. To transmit an audio signal, connect
an audio cable.
Plasma
OPTICAL
AUDIO IN AUDIO IN DIGITAL
(RGB/DVI) (RGB/DVI) AUDIO OUT
RS-232C IN
RGB IN (PC) RGB IN (PC)
(CONTROL&SERVICE)
WIRELESS
CONTROL
LAN
VIDEO L/MONO AUDIO
2
Y P P L
B R
1
VIDEO AUDIO
RGB OUT (PC)
AUDIO OUT
COMPONENT
IN1
WIRELESS
CONTROL
LV5500, LW5700, LW9500 series
AV IN1
AUDIO IN AUDIO IN AUDIO IN AUDIO IN OPTICAL DIGITAL
LAN RGB IN (PC) RGB IN (PC)
(RGB/DVI) (RGB/DVI)
RGB OUT (PC) AUDIO OUT
LZ9700 series
VIDEO
AUDIO
LAN RGB IN (PC) RGB IN (PC)
RGB OUT (PC) AUDIO OUT
R
/DVI IN
AV IN2
R
ANTENNA IN CABLE IN
AV IN 2
AUDIO / VIDEO
PTICAL DIGIT TICAL DIGIT ANTENNA TEN EN CABLE ABL ABL
COMPONENT IN 2 H/P
AUDIO OUT IN IN
AUDIO / Y P P
B R
IN 1 N
COMPO
AV
NENT
Y
RS-232C IN
OPTICAL
P
B
DIGITAL
ANTENNA CONTROL&SERVICE
P
R
AUDIO OUT IN CABLE IN
NOTE
1920X1080 is the recommended PC
y y
resolution. If you use the TV in other video
modes, afterimages or distorted images may
appear on the screen.
Depending on the graphics card, DOS mode
y y
may not work if a HDMI to DVI Cable is in
use.
In PC mode, there may be noise associated
y y
with the resolution, vertical pattern, contrast
or brightness. If noise is present, change
the PC output to another resolution, change
the refresh rate to another rate or adjust the
brightness and contrast on the PICTURE
menu until the picture is clear.
The synchronization input form for Horizontal
y y
and Vertical frequencies is separate.
Depending on the graphics card, some
y y
resolution settings may not allow the image
to be positioned on the screen properly.
If you experience overscan issues when
y y
using HDMI-PC 1920x1080, change aspect
ratio to Just scan.
When selecting HDMI-PC, set the "Input
y y
Label - PC" in the INPUT menu.