Siemens slider SL45 Operating Instructions Manual page 11

Do not use descaling agents for rinsing
out the boiler, as they could damage it.
Automatic clean warning
Pilot light (11) will flash indicating that
boiler must be rinsed.
e
1
n
ºC
o
3-4
e
6 a
7
8
9
t * Model dependent
2
A
~2 h.
5
b
0,25 L.
1. Check carefully that the appliance is
cold and unplugged for more than 2
hours, and that the water tank (1) is
empty.
2. Fix the iron to the stand by inserting
the tip of the iron into the front slot
and moving the fixation lever (13)
against the heel of the iron.
3. Place your appliance over a sink or
2
bucket.
4. Lean the appliance on the opposite
side of the filter opening.
5. Unscrew the filter (4) and take it out.
6. (model dependent)
To wash the filter, you may:
a. Place the filter under the water tap
and wash it up until calc residues
are removed. Squeeze the filter as
indicated in the picture 6a.
b. Immerse the filter in tap water (250
ml) mixed with a measure (25 ml)
of descaling fluid.
25 ml
The descaling fluid can be obtained
from our After-sales service or from
250 ml
our website.
Accessory code
(After-sales)
311144
7. Holding your steam generator in the
lateral position and using a jug, fill
the boiler with 1/4 litre of water and
replace the filter.
8. Shake the base unit for a few
moments, unscrew the filter again
and empty the boiler completely over
a sink or bucket.
For best results, we recommend that
x2
this operation is performed twice.
Important: before re-closing, make
sure no water remains in the boiler.
9. Replace and tighten up the filter.
To reset the "calc'nClean" counter,
switch the steam station off twice,
keeping it off for at least 30 seconds
each time.
(on → 30s off → on → 30s off → on)
Name of
accessory
(Online shop)
TZ11001
11
S IEME NS