"Intelligent Steam" Function; Energy Saving Button; Auto Shut-Off; Fabric Protection Soleplate Cover - Siemens slider SL45 Operating Instructions Manual

"Intelligent steam"
8
function
(model dependent)
This system has intelligent steam
control, which, after releasing the
steam release button (16), provides a
small amount of additional steam.
The additional steam can always be
stopped by briefly pressing the steam
release button once again.
Energy saving
9
button
(model dependent)
If the "Energy saving" button (8*) is
switched on, you can save up to 25%
of the energy and 40% of the water
consumption (*), and still achieve
good results when ironing most of your
garments.
It is advisable to use the normal energy
setting only for thick and very wrinkled
fabrics.
(*) In comparison to the maximum
setting.
Note: If you work with the "Energy
saving" function, the variable steam
regulation and temperature regulation
can still be used as recommended.
10

Auto shut-off

(model dependent)
If during ironing, the steam release
button (16-17*) on the iron handle
is not pressed for a certain length of
time (8 minutes), the steam station will
automatically switch off.
The "auto shut-off" pilot lamp (9) will
flash when auto shut-off has been
activated.
To switch the steam station back on,
press the steam release button again.
10
S I E M E N S
Fabric protection
11
soleplate cover
(model dependent)
The fabric-protection soleplate cover
(20*) is used for steam-ironing delicate
garments at maximum temperature
without damaging them. Use of the
soleplate cover also does away with
the need for a cloth to prevent shine on
dark materials.
It is advisable to first iron a small
section on the inside of the garment to
see if it is suitable.
To attach the soleplate cover to the
iron, place the tip of the iron into the
end of the soleplate cover and pull the
elastic strap over the lower rear of the
iron until it fits tightly. To release the
soleplate cover, pull the elastic strap
and remove the iron.
1
2
The fabric-protection soleplate cover
may be purchased from our customer
service or from our website:
Accessory code
(After-sales)
571510
12

calc'nClean Plus

Cleaning the Boiler
To extend the life of your steam
generator and to prevent any build up
of scale, it is essential that you rinse
out the filter (4) and the boiler after
several hours of use. If the water is
hard, increase the frequency.
3
Name of
accessory
(Online shop)
TZ20450
* Model dependent
D
ou
A
Pi
bo
1
3
6
7
8
9
* M