Yamaha CL5 Reference Manual page 59

7
Dynamics type buttons
Enable you to select the dynamics type. You can choose from the following dynamics types.
• Dynamics 1 for an input channel
GATE, DUCKING, COMPRESSOR, EXPANDER
• Dynamics 2 for an input channel
COMPRESSOR, COMPANDER-H, COMPANDER-S, DE-ESSER
• Dynamics 1 for an output channel
COMPRESSOR, EXPANDER, COMPANDER-H, COMPANDER-S
8
Dynamics graph
This graph displays the input/output response of the dynamics processors.
9
Dynamics parameter setting knobs
Indicate the dynamics parameter values. You can adjust the values by using the multifunction
knobs.
The type of parameters will vary depending on the currently-selected dynamics type.
• GATE or DUCKING:
• COMPRESSOR or EXPANDER:
• COMPANDER-H or COMPANDER-S:
• DE-ESSER:
0
Dynamics IN/OUT level meters, GR meter
These meters indicate the peak level of the signals before and after the dynamics processing, and
the amount of gain reduction. For a stereo channel, these meters indicate the level of both the L
and R channels.
A
KEY IN SOURCE select button
Press this button to display the KEY IN SOURCE popup window, in which you can select a key-
in signal that will trigger the dynamics.
B
KEY IN FILTER parameter area (Displayed only for GATE or DUCKING)
Enables you to make various settings for a filter that lets the key-in signal pass.
• Filter select buttons .................. Select the type of filter from HPF, BPF, or LPF. To disable the
• Q knob......................................... Indicates the filter Q. You can adjust the value by using the
• FREQUENCY knob .................. Indicates the filter cutoff frequency. You can adjust the value by
C
KEY IN CUE button
Enables you to cue-monitor the signal that has been selected as the KEY IN SOURCE signal. Cue
will be canceled if you have selected a dynamics type that does not feature this button, or if you
move to a different screen.
59
filter, press the button that is turned on.
multifunction knob.
using the multifunction knob.
EQ and Dynamics
Reference Manual