Table of Contents
Advertisement
Color Temperature (White Balance)
Adjustment
You can adjust manually or automatically with a specified
color temperature probe.
Note
When the DVI Computer signal or computer signal input of
HDMI is displayed, the color temperature cannot be
adjusted automatically.
Perform the manual adjustment of the color temperature.
Automatic adjustment
Use one of the following probes.
• Konica Minolta CA-210
• DK-Technologies PM5639/06
• X-Rite Eye-One Pro
1
Connect the color temperature probe.
For the cable to connect the color temperature probe,
see page 127.
2
Select Auto Adjust (page 47) in the Color Temp Adj
menu of the Adjustment menu and adjust the color
temperature.
Manual adjustment
1
Select Manual Adjust (page 46) in Manual of the Color
Temp Adj menu of the Adjustment menu.
2
Adjust the color as desired with the PHASE,
CHROMA or BRIGHT knob.
3
Press the ENTER or Ent button.
The adjusted data is confirmed.
Brightness/Contrast Adjustment
As an image on a color video monitor is seen differently
according to the ambient light (environmental brightness),
adjust the brightness (black level) according to the ambient
light and the black level of the image to be reproduced and
adjust the contrast (white level) according to the ambient
light.
Adjust the brightness/contrast with an external reference
signal of a multi format color-bar signal or SMPTE color-
bar signal.
1
Input the multi format color-bar signal or SMPTE
color-bar signal to the monitor.
32
Adjusting
The following are explained as the example when the
multi format color-bar signal is used for adjustment.
2
Select the Manual Adjust menu (page 45) in the Picture
Adj menu of the Adjustment menu.
3
Adjust the –2%, 0% and +2% ranges or the 0%, +2%
and +4% ranges of the PLUGE signal section of the
color-bar with the BRIGHT knob.
HD signal
Adjust so that the –2% and 0% ranges are seen as equal
and the +2% and 0% ranges are more distinctive.
SD signal
Adjust so that the 0% and +2% ranges are seen as equal
and the +2% and +4% ranges are more distinctive.
4
Adjust so that the luminance of the 100% white signal
of the color-bar is set to the desired value with the
CONTRAST knob.
We recommend adjusting the luminance to 100 [cd/
2
m
] when Preset1 to Preset5 is selected in the Picture
Preset menu of the Input Configuration menu.
5
As the brightness and contrast adjustments affect each
other, repeat the adjustments of step 3 and 4.
Note
When the contrast of this unit is adjusted, the luminance of
the backlight is adjusted for a picture of luminance 40 [cd/
2
2
m
] (20 [cd/m
] in black frame insertion or interlace
display mode) or higher, and the contrast is adjusted by the
signal level for a picture of luminance lower than 40 [cd/
2
2
m
] (20 [cd/m
] in black frame insertion or interlace
display mode).
SD
SD
SD
HD
+4%
0%
-2%
+2%
0%
Advertisement
Table of Contents
