How To Drain; Water Tank; Continuous Drainage - Sharp DW-D20A Operation Manual

Dehumidifier sharp dw-d20a
Table of Contents

Advertisement

HOW TO DRAIN

WATER TANK

When the water tank becomes full (approx. 4.2L), the
operation will automatically stop (Full tank stop device)
Laundry Deodorizing may be operated with a full tank. The Tank
FULL indicator light (red) will not blink during this time.
When the water tank is placed back after draining, the Tank FULL
indicator light (red) will go off and operation will start again.
1
Water tank
Tank knob
2
Drain outlet
3
Always stop the operation and dispose water before moving the main unit.
(Water in the tank may spill and damage household goods.)
NOTE
Clean the inside of water tank periodically (about once a week).
(Failing to clean for a long period of time may increase mold and bacteria which causes bad odor.)
16
Beep
Beep
Blinking
FULL
Take out the
Pull out straight while holding
water tank
down the main unit.
Gently pull out and carefully carry
without tilting or dropping so no
water will spill.
Dispose water
Push in completely.
Set the water
Gently push in.
(Rough handling may cause
tank to the
malfunction.)
main unit

CONTINUOUS DRAINAGE

Important Notices When Using
Continuous Draining Operation.
This dehumidifier is made for household use. When
conducting Continuous Drainage, check for dirty filters (once
every two weeks) and clogging of drain hoses periodically.
Place the drain hose where the temperature will not fall
below zero.
(When the water in the hose freezes, the water inside the
main unit may leak into the room and soak household goods)
Put a net over the hose tip to prevent from insects coming in.
Auto Off function will operate after 12 hours for Continuous
Drainage as well. To release the Auto Off function, please
read "To cancel the Auto Off function" on
Page 11
.
1
Water tank
2
Rubber cap
Tank knob
Drain outlet
Drain stopper
Continuous
drainage hole
3
Press with your
Insert with your left hand
Commercial hose inner
right finger
diameter 15mm (outer
diameter up to 21mm)
4
If there is a place you
can drain nearby,
continuous drainage is
possible.
How to pipe the hose
Do not put the
Always have
Do not bend
hose tip into
the tip slanted
the water
10cm
or more
To stop continuous drainage
and restore the original position
Take the hose off from drain outlet and put
the rubber cap on.
Unplug the power plug
Take out the water tank
and take off the rubber
cap on the back side
While pressing the drain stopper
with your right finger, run the
hose through the continuous
drainage hole on the back of the
main unit and securely insert
into drain outlet
Do not use an old
Hose
hose with wide
opening.
(Otherwise, water
may leak.)
Make sure the hose is inserted
all the way in.
Set the water tank
to the main unit
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents