Asus E3060 WiFi-AP Solo User Manual page 39

Table of Contents

2. Set up the operation

channel and the

wireless network

security settings. The

operation channel and

security settings must

be identical with the Ad-

hoc nodes you want to

connect. Click Finish to

apply and return to the

setup utility.

Refer to Appendix for the available wireless LAN channels in your country

or region.

3. To connect an Ad-hoc node, you must manually set up the IP address of

WiFi-AP Solo. Double-click the wireless icon in the system tray -> click

Properties -> double-click Internet Protocol (TCP/IP) to open the IP

configuration page.

Make sure that the IP address of the

ake sure that the IP address of the

WiFi-AP Solo is within the same subnet

as that of the station. For example, if the

IP address of the station is 192.168.0.1,

then the IP address of WiFi-AP Solo

must be 192.168.0.X, where X = 2 ~

254. When the setup is complete, click

OK.

4. Click the Status button of the

setup utility to check whether the

connection is established.

3-22

Table of Contents