Charging 5 V Devices With The Power Pack - Silvercrest KH 997 Operating Instructions Manual

Charging 5 V devices with the Power Pack

Preparation
1. Check for the maximum input voltage of the device that you want
to charge. For this consult the operating instructions of the device.
2. Make sure that the maximum current consumption does not
exceed 800 mA.
3. Check to see which plug connection attachment is required for the
device (see compatability table S. 70 + 71).
Charging of 5 V devices
IMPORTANT
► Devices with a USB connection that require an input voltage
corresponding to the USB specifi cations of 4.75 V – 5.25 V
®
(iPod or iPhone
attachment USB-USB (UA01) 0. The current draw of these
devices must be at least 100 mA.
1. Insert the plug of the retractable USB cable u into the socket
USB OUTPUT 3.
2. Connect the appropriate plug connection attachment to the other
end of the retractable USB cable u.
3. Insert the plug connection attachment into the device's power
supply socket.
4. Press the rechargeable battery test button 2. The device now
receives its power supply from the Power Pack. If the device has a
charging indicator this will show that the device is being charged.
KH 997
®
) must use the supplied plug-in connector
GB
MT
63