Before asking for repair, please make the following checks. If you cannot correct the trouble, contact your dealer.
Symptom
Image is not projected.
• Power plug is not properly connected to outlet.
• Power switch is not on.
• Projector or display is not properly connected.
• Brightness setting is not correct.
• 'EXTERNAL' or 'MEMORY' is selected in source selection. Select 'CAMERA'.
• Mode setting of image is not correct. Set according to projector or display to be
connected.
• Settings of dip switches on back panel are not correct.
Image is not focused.
• Material is too close to lens (it is 88mm or higher from stage surface).
• ZOOM has been changed after focusing. Carry out focusing with ZOOM set.
• In 'AUTO' of focusing, some object may not allow easy focusing.
Adjust by 'NEAR' or 'FAR' button of FOCUS.
• When projector is used, projector is not properly focused.
Adjust focus as instructed in projector manual.
• Camera image cannot be adjusted when FREEZE mode is selected ('REAL/
FREEZE' indicator off) or when 'EXTERNAL' or 'MEMORY' is selected in source
selection. Turn on REAL mode by pressing 'REAL/FREEZE' button, and select
camera image by pressing 'CAMERA' button of source selection.
Zoom cannot be ad-
• Zoom is at down end or up end.
justed.
• Digital zoom is selected.
Change magnification of digital zoom by pressing button step by step.
Image is blurred or dust
• Camera lens is dirty. Clean with commercially available camera lens cleaner.
is shown.
Image is dark
• Main light is not on.
• BRIGHTNESS is not properly adjusted.
Stripes appear in im-
• Interference between mesh points of printed matter and image of camera shooting
age of printed matter.
elements may sometimes produce color stripes. In such a case, change image
size a little by ZOOM.
Color tone is not cor-
• White balance is incorrectly adjusted.
rect.
• Negative mode or black-and-white mode is on.
Beating appears in im-
• Beating may appear in image when equipment is used near source of strong radio
age.
waves. Separate from such source.
Image cannot be ad-
• Camera image cannot be adjusted when FREEZE mode is selected ('REAL/
justed.
FREEZE' indicator off) or when 'EXTERNAL' or 'MEMORY' is selected in source
selection. Turn on REAL mode by pressing 'REAL/FREEZE' button, and select
camera image by pressing 'CAMERA' button of source selection.
• There are cases where BRIGHTNESS adjustment cannot raise brightness suffi-
ciently.
Operation does not oc-
• Correct operation may not follow if two buttons are pressed simultaneously or if a
cur at button press.
button is hit in quick succession. Operate buttons one by one with sufficient inter-
vals.
Remote control does
• Batteries are not set in remote control.
not work.
• Voltage of batteries is low.
• Batteries attached are for operation check only. Use batteries available on the
market.
• Remote control is operated outside usable range.
White or black dots ap-
• Due to characteristics of moving image high-pixel CCD, white or black dots may
pear in camera image.
appear on rare occasions and can be conspicuous when enlarged by digital zoom.
All indicators remain lit
• The equipment is in trouble. Contact your dealer for instructions.
even a few minutes af-
ter power on.
Troubleshooting
Check for the cause
E-19
See page
E-13
E-14
E-12
E-9
E-9
––
E-10
––
E-14
E-9
––
E-9
––
E-9
––
E-9
E-9
E-9
E-9
E-9
––
E-9
E-9
––
––
––
––
E-11
––
––