Advertisement
7.4. TEMPERATURE SETTING PROCEDURE
CAUTION:
- Do not touch "CHECK" switch.
- "CHECK" switch is for servicing only.
- If the mode is changed to checking mode by incorrect operation, the mode is changed to
previous mode by pressing "RESET" switch.
1. Select the unit by pressing "UNIT SELECTION" switch.
(Refer to item 1 of page. 11)
NOTE:
This procedure is not performed during multiple-unit
control.
2. Press "TEMP" switch and set required temperature.
Press " " switch at once, setting temperature is
increased by 1 °C. Press "
temperature is decreased by 1 °C.
Temperature setting range is different according to the
unit.
NOTE:
Setting temperature is changed continuously if pressing the switch is maintained.
In case of the multiple-unit control is selected and "UNIT SELECTION" switch is pressed, "NO
FUNC." is indicated. Unit No. is always indicated "AA" when all the units are operated
simultaneously, in normal mode.
OPERATION PROCEDURE
COOL
UNIT No.
MULTI
INLET
SET TEMP.
℃
TIMER
INDVDL
OUTLET
TEMP. PR.
MPa
EMG.STOP
HEAT
NO FUNC.
DEMAND
H.RCV.
1
2
3
4
5
6
7
8
A/C
H.STRG
LOCAL
ABNML
CHECK
UNIT SELECTION
RUN/STOP
MODE CHANGE
A/C／H.STRG
DISP.MODE
TIMER
OPTION
GROUP
TEMP.
" switch at once, setting
RESET
1
CHECK
CHECK
2
COOL
UNIT No.
SET TEMP.
INDVDL
1
2
3
4
A/C
The above figure shows the
case of selecting unit No.4.
COOL
UNIT No.
SET TEMP.
INDVDL
1
2
3
4
A/C
The above figure shows the
case of setting temperature at
12°C.
13
℃
℃
Advertisement
