Advertisement
2
INSTALLATION WORK
2.3. INSTALLATION SPACE
In case of installing the controllers in vertical line
keep a distance more than 50mm between the
controllers vertically.
If the distance is insufficient, the front cover of
the controller can not open wide enough
1.Insert the edge of the screwdriver into the slot parts at the bottom of the holding bracket, push and
turn the screwdriver and remove the controller from the holding bracket. Do not insert the
screwdriver into the nail near the slot part, or the nail will be damaged.
Control Part
Power Supply Part
Approx. 6mm
Screw
Slot Part
Driver
2. Attach the power supply part to the switch
box.
3. Attach the control part onto the power supply
part. At first, attach the upper side, and then
the lower side.
More than 50mm
Figure Seen from Bottom Side
Slot Part
Screw
Driver
Do not run the power line and the
control line through the same conduit
Power
Line
Power Supply
Screw
(x2)
Switch Box with Cover
(Field-Supplied)
Nail
Control
Line
Advertisement
