Inspection Mode Of Service Man - Sanyo ASW U1100T Service Manual

10. Inspection mode for service man
Method to enter service inspection mode:
(1) While holding the PROGRAM button down at pressed state, press the POWER SWITCH button.
(2) Hold the program button down at pressed state, press the START/ PAUSE button three times.
The operation of inspection mode:
(1) Press PROGRAM button to set the inspection mode.
(2) Press only START/ PAUSE button to start the inspection mode.
Setting
Inspection
course
The motor rotates
NORMAL
clockwise.
The motor rotates
HEAVY
counter clockwise.
DUTY
The drain valve
CUSTOM
operates.
The Magnetic
DRY CARE
Valve operates.
Method to enter child safety inspection mode :
(1) Turn power switch on.
(2) Press and hold the WATER LEVEL for 4 seconds or more until sounds beep and the indicator of
CHILD SAFETY will light on.
NOTE:
Press the WATER LEVEL button again for 4 seconds or more until sounds beep and indicator of CHILD
SAFETY will light off in order to delete CHILD SAFETY inspection mode.
Confirmation
Does Pulsator rotate
clockwise ?
Does Pulsator rotate
counter clockwise ?
Does drain valve open ?
Is water drained ?
Does Magnetic Valve open ?
Is water supplied ?
- 11 -
Purpose
Check the operation of Motor, Bearing Ass y
and PCB.
Check the operation of Motor, Bearing Ass y
and PCB.
Check the operation of Magnetic Coil and
Drain valve.
Check the operation of Magnetic Valve and
PCB.