Advertisement
TEST MODE
*
(6) Key Monitor detection
Each time a key is pressed, the TALK LED lights and the key monitor sounds.
(7) Return to the usual mode
By turning off the power and retry, usual mode will start.
5.
Key monitor inspection
mode
Keys are pressed disorderly, and if after all keys except INT key have been pressed at least once the TALK LED and BATT LED lights
for approximately
one second and a buzzer sounds.
(1) Initial status (Simultaneously
pressed)
TX POWER
TX MUTE
RX POWER
RX MUTE
CH
pressed
Key monitor mode
OFF
ON
ON
ON
10
1 and O
(2) Battery low detection
The BATT LOW LED and buzzer is set on for 500msec.
&
The BATT LOW LED is operated by Integrated circuit (ICO02).
(3) Charge detection
When CHARGE is detected, the TALK LED is lit.
(4) Return to the usual mode
By turning off the power and retry, the usual mode will start.
6.
Ignore security code mode
Through the base receiving a specific security code and channel (security: AC34H, channel:
10ch), this mode allows linking of the
remote and base without security registration
by the remote. Other operations
perform as usual.
(1) Startup
The REMOTE enters this mode by simultaneously
pressing the 1 and 8 keys.
(2) Return to the usual mode
By turning off the power and retry, the usual mode will start.
<Frequency table>
A
channel No.
1 (1)
2 (3)
3 (5)
4 (7)
5 (9)
6 (2)
7 (4)
8 (6)
9 (8)
10(10)
Base TX (MHz)
30.075
30.125
30.175
30.225
30.275
30.100
30.150
30.200
30.250
30.300
Remote TX (MHz)
39.775
39.825
39.875
39.925
39.975
39.800
39.850
39.900
39.950
40.000
NOTE: (
) means New channel (AS/NZS 4281: 1995)
J
-18-
Advertisement
