Channel Plan Adviser Window; Pairing Receiver Channels And Transmitters - Sony DWR-R02D User Manual

RF Power: Configure settings for the transmitter's
transmitted power.
Input Level: Displays the transmitter's audio input level.
ATT: Sets the attenuator for the transmitter. You can only
change this setting when "Input Level" is set to "MIC."
LCF: Configure settings for the transmitter's low-cut
filter.
+48V: Configure settings for the transmitter's +48 V
power supply.
Time: Displays the total usage time for the transmitter.
Clicking the "Reset" button clears the total usage time.
Internal SG: Specifies whether to generate internal
signals on the transmitter.
Power SW Lock: Specifies whether to lock the POWER
switch on the transmitter.
Power SW State: Displays the status of the POWER
switch on the transmitter. This setting cannot be changed.
RF Remote menu
RF Remote: Configure settings for the wireless remote
control function.
Pairing button: Press this button to start pairing receiver
channels to transmitters.
For details on pairing, see "Pairing Receiver Channels
and Transmitters" on page 14.

Channel Plan Adviser Window

This window allows you to enter signal environment
information and use the receiver's channel scan function to
select a channel plan that is suitable for the signal
environment.
The signal environment information entered and the
signals detected with the channel scan are displayed in the
spectrum graph in the upper part of the screen. This allows
you to select the channel plan while viewing signal usage
in the spectrum graph.
The following modes are available in Channel Plan
Adviser.
Basic mode: This mode allows you to select a channel plan
that avoids signal interferences detected by the receiver's
channel scan function. This is a simplified method that
omits information entry other than the channel scan.
Advanced mode: In addition to performing channel scan
as in Basic mode, this mode allows you to enter various
information you obtained beforehand to select an
30
Setup Windows
appropriate channel plan. You can enter the following
information.
• Interference resulting from TV broadcasts
• Interference resulting from other wireless devices
• Interference detected by the channel scan
• The amount of frequency clearance to leave between
interference when selecting the channel plan
For details on selecting channel plans using Basic mode,
see "Selecting Channel Plans" on page 13.
1
a Contents area
Displays the steps to perform when using Channel Plan
Adviser and allows you to save or load a work file.
1
3
A Completion mark
Displays a check mark for completed steps. This allows
you to view your progress and check for missed steps.
2
3
2