Troubleshooting; Information Codes Table (For Facsimile) - Panasonic UF-580 Service Manual

3 Troubleshooting

3.1.

Information Codes Table (For Facsimile)

Code Mode
001 RCV
COPY
002 RCV
COPY
007 RCV
COPY
010 RCV
COPY
011 STANDBY
012 RCV
021 STANDBY
RCV
COPY
030 XMT
031 XMT
COPY
041 STANDBY
RCV
COPY
043 STANDBY
RCV
COPY
045 STANDBY
051 RCV
COPY
054 STANDBY
RCV
COPY
060 -
Fax Information Codes
Phase Description of Problem
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor.
(1st Cassette)
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor.
(2nd Cassette)
C, D 1.Leading edge of the recording
paper fails to reach the Paper
Exit Sensor.
2.Recording paper has not
completely passed the Paper
Exit Sensor.
B, C No recording paper.
B, C Paper Cassette is not installed
properly.
C, D The length of the received
document is over 2 meter (78.7in).
B, C, D Thermistor is abnormal.
Fuser Control is abnormal.
Fan is abnormal.
B Read Point Sensor does not go
ON within 10 seconds after the
document starts feeding.
C Transmitting document was longer
than 2 meter (or 78.7 in).
B, C, D Out of toner.
B, C, D Low toner.
- No Toner Cartridge.
- Printer Motor abnormal.
- HSYNC abnormal.
Motor abnormal.
A Printer Cover is open.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Paper Exit Sensor abnormal.
No recording paper or paper is not set
properly.
No Paper Sensor is defective.
Defective SC PCB.
Defective Fuser Unit, Power Supply
Unit.
Defective Fan.
Document is not set properly.
Defective Read Point Sensor.
The document may jam.
Defective Read Point Sensor.
No toner.
Defective Toner Sensor.
Toner is getting low.
Defective Toner Sensor.
Toner cartridge has not been installed.
Defective Toner Sensor
(Cartridge Sensor).
Connector not properly connected.
Defective Printer Motor.
Defective SC PCB.
Defective Laser Unit.
Cover is not firmly closed.
Connectors are not firmly connected.
21
Cause