Table of Contents
Advertisement
Display
It is hard to view the LCD.
The cursor cannot be con-
trolled.
The cursor does not prop-
erly correspond to a stylus
tap.
Connecting a Host PC
A host computer does not
recognize CF-P1.
Connecting Peripherals
Peripheral is not recognized
even after driver is installed.
Network
Cannot connect to the net-
work.
Sounds
Quality of recorded sound is
poor.
Character Input
< Only for CF-P1S1 series >
Entering characters
The LCD backlight may have automatically turned off
due to the power-saving function. Turn on the LCD
backlight by holding down the power switch until the
backlight goes on.
Adjust the backlight brightness.
1 Tap
- [Settings] - [System] tab - [Backlight].
2 Tap the [Brightness] tab and adjust the brightness
with the slider.
Push the reset switch to restart.
Align the screen (
page 20).
®
Confirm that Microsoft
sion) has been installed in the host computer.
Check to see if a fully charged battery pack is properly
installed to CF-P1.
If a modem card has been inserted, disconnect these
devices and check the communication status again.
Confirm that CF-P1's power is on.
Push the reset switch to restart.
If a cable or cradle is being used for the connection,
recheck the connection to the host computer.
Remove cards or other peripherals, and push the
reset switch.
Check the server information and network settings.
Tap
- [Settings] - [Personal] tab - [Input] - [Options] tab
- [Voice recording format], and select a higher frequency.
Characters can be input using the input panel.
(
page 22)
®
ActiveSync
3.5 (or a later ver-
39
Advertisement
Table of Contents
