Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Sanyo SC-F298
Summary of Contents for Sanyo SC-F298
-
Page 2: A Few Precautions
A FEW PRECAUTIONS Vacuum cleaner: SANYO SC-F298, Voltage: AC220-240V, Frequency: 50-60Hz; Power:1600W 1. Operating without the dust compartment and/or filters in place will allow dust to enter the motor and could damage the vacuum cleaner. 2. Keep the vacuum cleaner away from stoves and other heat sources. - Page 3 A FEW PRECAUTIONS 11. If the supply cord of this appliance is damaged, it must only be replaced by a repair shop designated by the manufacturer, in order to avoid a hazard. 12. Do not allow it to be used as a toy. Close attention is necessary when used by or near children or infirm persons.
-
Page 4: Name And Function Of Parts
NAME AND FUNCTION OF PARTS (Assemble as indicated in the center illustration) Cord rewind button Power control Switch Set the POWER To pull the cord back into the unit, Start or stop CONTROL to “+” for press the cord rewinder button. vacuum maximum suction. -
Page 5: Dust Disposal
DUST DISPOSAL If there is a reduction in suction power, turn off the vacuum cleaner, disconnect the hose and proceed as follows: 1. To separate the dust compartment from the vacuum cleaner, push the clamp button as shown. Clamp button Dust compartment 2. -
Page 6: Filter Care
FILTER CARE When the suction power is low and the dust has been discarded, the filter still should be cleaned. 1. Clean the filter with the cleaning utensil. cleaning utensil 2. Lightly tap the filter to remove the dust. If you are concerned about dust on the filter. 1. -
Page 7: Care And Maintenance
HOW TO USE THE HOSE STAND The vacuum cleaner with the floor brush, wands and hose can be stored while still connected. Wind Hold here 1. Stand the vacuum cleaner up and insert the wand-holder into the wand-holder hole. Wand-holder 2.