Buzzer Volume; Keypad Tone; Conductivity - Miele TMV 840 WP Operating Instructions Manual

Settings menu

Buzzer volume

The buzzer sounds to indicate the end
of the programme. It can be set to be
louder or quieter or switched off.
The continuous tone which sounds
when there is a fault is independent of
the buzzer.
The setting selected is shown in a bar
chart.
Factory default: a medium setting.
–
     
Switched off
–
      
Quieter
–
      
Louder
You will hear the buzzer change as the
setting is selected.
 Confirm with the

Keypad tone

When this setting is activated a tone
will sound each time a sensor is
touched.
Options
–
On
– (Factory default setting)
Off
94
sensor.
OK

Conductivity


The option should only be
Low
selected if the residual moisture
reading in your laundry is incorrect
due to extremely soft water.
Options
– (Factory default setting)
Normal
–
Low
Conditions
The Low option should only be set if the
water used for washing the laundry is
extremely soft with a conductivity read‐
ing (electrical conductivity) less than
150 μS. Contact your local water au‐
thority for the conductivity level of your
mains water supply.

Only activate the Low option if
the above conditions are present.
Otherwise drying results will be un‐
satisfactory.