Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Frigidaire FDH25J
Summary of Contents for Frigidaire FDH25J
- Page 4 This service manual is intended for use by persons having electrical and mechnical training and a level of knowledge of these subjects generally considered acceptable in the appliance repair trade. Frigidaire cannot be responsible, nor assume any liability, for injury or damage of any kind arising from the use of this manual.
- Page 14 EPA certification for servicing refrigeration systems. Frigidaire does not permit the use of recovered refrigerant in the servicing of our products for in-warranty and out-of-warranty repairs or for products covered by service contracts. Therefore, only new refrigerant or refrigerant that has been reclaimed back to new specifications by a refrigerant manufacturer is to be used.
- Page 15 3. Apply thin film of liquid flux recommended for silver soldering to surfaces to be joined, and to surfaces Operate the unit for at least 30 minutes in a room immediately adjacent to joint. temperature of 75°F to 85°F. The top of the compressor 4.
- Page 16 leak testing, as flux can seal off pinhole leaks that would show up later. To Use Refrigerant To Flush The System: When replacing components, all copper joints must be joined with silver solder or Sil-Fos. 1. Remove suction and discharge lines on compressor and disconnect capillary tube from condenser.
- Page 17 in the oil and the compressor. Also, avoid opening the system 4. To replace capillary tube, unsweat tube from evaporator when any of the components or lines are cold. and condenser. Remove and replace. 5. To replace evaporator, unsweat capillary tube and suction line.
- Page 18 1. Disconnect dehumidifier from electrical supply. 2. Install process tube adaptor on process tube leaving as much tube as possible. 3. Attach refrigeration service gauge manifold to system in following order: • Low-side (compound gauge) to process tube • Center port manifold hose before hand shut-off valve to charging cylinder.
- Page 19 WIRING DIAGRAMS - DATA SHEETS ELECTRICAL WIRING DIAGRAM Single Speed Fan - Models With Reciprocating Compressors...
- Page 20 ELECTRICAL WIRING DIAGRAM 2 Speed Fan - Models With Reciprocating Compressors...
- Page 21 ELECTRICAL WIRING DIAGRAM 2 Speed Fan - Models With Rotary Compressor...
- Page 22 : l l : l l : . l i r t - i t...
- Page 23 : l t : l l : l l : . l i r t - i t...
- Page 24 : l t : l l : l l : . l i r t - i t...
- Page 25 : l t : l l : l l : . l i r t - i t...