Panasonic AG-HMX100P Operating Instructions Manual page 64

[DECAY]
The afterimage effect can be added to video.
The following diagram shows an example of the decay
effect.
Decay effect
Rotary 1 Rotary 2 Rotary 3
DECAY TIME
OFF
OFF 0-32
ON
Select [ON] or [OFF] to specify whether or not to apply the
effect using the rotary 2 control.
The factory default setting is [OFF].
Set [TIME] in the range of [0] to [32] using the rotary 3
control.
The factory default setting is [16].
This time setting is applied to No. 1066 (219) pattern.
 NOTE
The decay effect cannot be applied to both input source video
A and B at the same time. When the decay effect is enabled for
one video, it is automatically disabled for the other video.
[PAINT]
The image tone can be decreased to generate painting-like
video.
The following diagram shows an example of the paint
effect.
Paint effect
Rotary 1 Rotary 2 Rotary 3
PAINT LEVEL
OFF
OFF 0-7
ON
Select [ON] or [OFF] to specify whether or not to apply the
effect using the rotary 2 control.
The factory default setting is [OFF].
Set [LEVEL] in the range of 0 to 7 using the rotary 3 control.
The factory default setting is 4.
This level setting is applied to No. 1034 (211) transition
pattern.
16
Rotary 4 Rotary 5
16
Rotary 4 Rotary 5
4
[NEGA]
The brightness of video can be inverted.
The following diagram shows an example of the negative
effect.
Negative effect
Rotary 1 Rotary 2 Rotary 3
NEGA Y C
OFF
OFF OFF
ON ON
Select [ON] or [OFF] to specify whether or not to apply the
Y signal negative setting [Y] using the rotary 2 control and
the chroma signal negative setting [C] using the rotary 3
control, respectively.
The factory default setting is [OFF] for both items.
[MIRROR]
The mirror effect can be produced in the horizontal or
vertical directions.
The following diagram shows an example of the mirror
effect.
Vertical direction
Mirror effect
Rotary 1 Rotary 2 Rotary 3
MIRROR H V
OFF
OFF OFF
ON ON
Select [ON] or [OFF] to specify whether or not to apply the
mirror setting in the horizontal direction [H] using the rotary
2 control and in the vertical direction [V] using the rotary 3
control, respectively.
The factory default setting is [OFF] for both items.
Rotary 4 Rotary 5
OFF
Horizontal direction
Horizontal and
vertical directions
Rotary 4 Rotary 5
OFF