[Save] Tab - Sony HVO-1000MD User Manual

[Capture]
Select whether to use the frame capture or field capture
mode in the setting screen that appears, and press the
ENTER button.
Note
The value that appears for [Rec Quantity] is an
estimate for single-layer BDs (25 GB).
4
When you finish configuration, use the V , v , B , and b
buttons to select [Apply], and press the ENTER
button.
The [MENU] screen appears again.

[Save] Tab

Configure settings related to external media used to store
recorded data, and specify whether to output metadata.
1
Use the B and b buttons to select the [Save] tab.
2
Configure each setting.
Select an item using the V and v buttons, and press the
ENTER button to display the setting screen for that
item.
[External Media 1], [External Media 2]
Select the external storage destinations in the setting
screens that appear, and press the ENTER button.
Notes
• You cannot specify the same storage destination for
both [External Media 1] and [External Media 2].
• For the HVO-3000MT, if [Simultaneous 3D and 2D
Rec] is set to [Yes] in the [System Admin Settings]
screen - [3D/2D Settings] screen, recordings will
only be saved to one external media destination.
Therefore, the [External Media 2] setting will be
ignored, even if it is configured.
[Record Copy Media]
Select the external storage media to which to copy the
recording list in the setting screen that appears, and
press the ENTER button.
[Metadata Output]
Specify whether to output metadata.
[Advanced] appears when you select [Yes].
For details on this setting, see "To configure metadata
output settings" (page 108).
107
Initial User Settings