Step 5: Setting The Default Mapping; Step 6: Confirming Vdisk Settings; Creating A Vdisk - HP P2000 G3 Reference Manual

Step 5: Setting the default mapping

Specify default mapping settings to control whether and how hosts will be able to access the vdisk's
volumes. These settings include:
• A logical unit number (LUN), used to identify a mapped volume to hosts. Both controllers share one set
of LUNs. Each LUN can be assigned as the default LUN for only one volume in the storage system; for
example, if LUN 5 is the default for Volume1, LUN5 cannot be the default LUN for any other volume.
• The level of access — read-write, read-only, or no access — that hosts will have to each volume. When
a mapping specifies no access, the volume is masked.
• Controller host ports through which hosts will be able to access each volume. To maximize
performance, it is recommended to map a volume to at least one host port on the controller that the
volume's vdisk is assigned to. To sustain I/O in the event of controller failure, it is recommended to map
to at least one host port on each controller.
After a volume is created you can change its default mapping, and create, modify, or delete explicit
mappings. An explicit mapping overrides the volume's default mapping for a specific host.
NOTE: When mapping a volume to a host using the Linux ext3 file system, specify read-write access;
otherwise, the file system will be unable to mount the volume and will report an error such as "unknown
partition table."
To specify the default mapping
1. Select Map.
2. Set the base LUN for the volumes. If this LUN is available, it will be assigned to the first volume and the
next available LUNs in sequence will be assigned to any remaining volumes.
3. In the enclosure view or list, select controller host ports through which attached hosts can access each
volume.
4. Select the access level that hosts will have to each volume: read-write, read-only, or no-access
(masked).
5. Click Next to continue.

Step 6: Confirming vdisk settings

Confirm that the values listed in the wizard panel are correct.
• If they are not correct, click Previous to return to previous steps and make necessary changes.
• If they are correct, click Finish to apply the setting changes and finish the wizard.

Creating a vdisk

To create a vdisk
1. In the Configuration View panel, right-click the system or Vdisks and then select Provisioning > Create
Vdisk.
2. In the main panel set the options:
• Vdisk name. Optionally change the default name for the vdisk. A vdisk name is case sensitive and
cannot already exist in the system. A name cannot include a comma, double quote, or backslash.
• Assign to. Optionally select a controller to be the preferred owner for the vdisk. The default, Auto,
automatically assigns the owner to load-balance vdisks between controllers.
• RAID Level. Select a RAID level for the vdisk.
• Number of Sub-vdisks. For a RAID- 1 0 or RAID-50 vdisk, optionally change the number of sub-vdisks
that the vdisk should contain.
HP StorageWorks P2000 G3 MSA System SMU Reference Guide 61