Specific Settings; Setting The Reset Groups - Fujitsu ETERNUS DX60 Configuration Manual

Chapter 2 Setting Up the ETERNUS DX
2.2

Specific Settings

2.2 Specific Settings
Some settings are not required for some OSes and/or connection configurations.
Check the various cases described below, and perform any required settings.
2.2.1

Setting the Reset Groups

If the system configuration matches any of the items "System configuration that requires the reset group set-
ting" in the following table, every ETERNUS DX port that connects to the given server's access paths must be
assigned to the same reset group.
For system configurations other than the following, use the default settings.
OS
Solaris OS
AIX
Windows Server
VMware vSphere (ESXi 5.5, ESXi 5.1, ES-
Xi 5.0, ESX 4.1, ESXi 4.1, ESX 4.0, ESXi
4.0)
VMware Infrastructure 3 (ESX 3.5, ESXi
3.5)
*1: For a Windows Server
2008 based WSFC configuration, the reset group settings are not necessary.
System configuration that requires the reset group setting
Cluster configuration
Single path configuration using FJspio for a PowerHA or HACMP cluster
MSCS configuration (*1)
®
2003
Multipath configuration
or
Multiple ESX servers share ETERNUS DX LUNs (*2)
®
2012 R2, Windows Server
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
®
2012, Windows Server
13
®
2008 R2, or Windows Server
P3AM-3182-15ENZ0
®