Chapter 2 Setting Up The Eternus Dx; Common Settings; Setting The To-Server Connection Type (Setting The Fc Port Parameters); Table 2.1 Fc Port Parameter Settings (Fc-Al Connection) - Fujitsu ETERNUS DX60 Configuration Manual

Chapter 2
Setting Up the ETERNUS DX
2.1

Common Settings

This section explains the settings required for all server OSs, regardless of the connection configuration.
See the "ETERNUS Web GUI User's Guide" for details of how to set up and operate ETERNUS Web GUI.
2.1.1

Setting the To-server Connection Type (Setting the FC Port Parameters)

For each connection configuration, set the indicated items only. Retain the default values for all of the pa-
rameters that are not described below.

Table 2.1 FC port parameter settings (FC-AL connection)

Parameter
Connection
Set Loop ID
Loop ID (*1)
Frame Size
Transfer Rate
Host Affinity
Reset Scope
Release Reservation if Chip is Reset
*1: Assign Loop IDs that are unique within each Loop, in ascending order.
*2: Set the appropriate value from the following table. Do not use [Auto].

Table 2.2 Transfer rate setting values

Fibre Channel card maximum speed
8Gbit/s
4Gbit/s
2Gbit/s
1Gbit/s
Solaris OS
FC-AL
Manual
Values from 0x10 upwards (except
0x7D)
2048 bytes (Default value)
See the table below (*2)
Enable
I_T_L (Default value)
Disable (Default value)
Transfer rate setting value
8Gbit/s CA
8Gbit/s
4Gbit/s
2Gbit/s
—
8
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
®
HP-UX, AIX, Windows , Linux, VMware
ESX, PAN Manager, Citrix XenServer,
Oracle Linux, Oracle VM Server
0x00
4Gbit/s CA
4Gbit/s
4Gbit/s
2Gbit/s
1Gbit/s
P3AM-3182-15ENZ0