Chapter 2 Setting Up The Eternus Dx; Common Settings; Setting The To-Server Connection Type (Setting The Fc Port Parameters); Table 2.1 Fc Port Parameter Settings (Fc-Al Connection) - Fujitsu ETERNUS DX80 S2 Configuration Manual

Chapter 2
Setting Up the ETERNUS DX
2.1

Common Settings

This section explains the settings required for all server OSs, regardless of the connection configuration.
See the "ETERNUS Web GUI User's Guide" for details of how to set up and operate ETERNUS Web GUI.
2.1.1

Setting the To-server Connection Type (Setting the FC Port Parameters)

For each connection configuration, set the indicated items only. Retain the default values for all of the pa-
rameters that are not described below.
Specify "Fabric connection" for connections to the Fibre Channel switches.
•
Specify "FC-AL connection" for direct connections to the Fibre Channel cards. Specify "Fabric connection" for
•
direct connections to 16Gbit/s Fibre Channel cards (maximum transfer rate) with a transfer rate of 16Gbit/s.

Table 2.1 FC port parameter settings (FC-AL connection)

Parameter
Connection
Set Loop ID
Loop ID
Transfer Rate
FC Frame Size
Reset Scope
Release Reservation if Chip is Reset
Solaris OS
FC-AL
Manual
Values from 0x10 upwards
(Except 0x7D)
See the table below (*1)
2048
I_T_L
Disable
8
FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection-
Copyright 2015 FUJITSU LIMITED
®
HP-UX, AIX, Windows , Linux, VMware
ESX, PAN Manager, Citrix XenServer,
Oracle Linux, Oracle VM Server for x86
0x00
P3AM-5332-15ENZ0