Changing The Connection Mode; Connecting The Projector; Connecting A Computer Equipped With A Dvi-D Connector - Sony SRX-T423 Operating Instructions Manual

Changing the Connection Mode

When the projector you want to operate is connected to the
computer via a network, you can select it by specifying the
IP address of the projector. Connection via the RS-232C is
also available.
When connecting the computer via a network by
specifying the IP address of the projector
Select [Network] from the [Connect] menu on the menu
bar to open the dialog. Enter the IP address and model
name of the projector, then click [OK].
To change the port number, select [PC Port Setting] from
the [Connect] menu on the menu bar to display the dialog.
Enter the new port number in the dialog and click [OK].
When connecting the computer via RS-232C
Select [COM] from the [Connect] menu on the menu bar
to open the dialog. Enter the port number and model name
of the COM port (RS-232C) for the computer, then click
[OK].

Connecting the Projector

When you connect the projector, make sure to:
• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose connections may
increase noise and reduce performance of picture
signals. When pulling out a cable, be sure to pull it out
from the plug, not the cable itself.
• When installing the optional input board, consult your
dealer or your local Sony representative.
• For connecting the cable to the connector inside the
projector, consult your dealer or your local Sony
representative.
Refer also to the instruction manuals of the equipment to
be connected.
Connecting a Computer Equipped
with a DVI-D Connector
Connect a computer with a DVI-D connector to the
optional LKRI-005 HDCP DVI input board installed to
any of INPUT A to INPUT D inside the projector.
53
Connecting the Projector