Using Camera - Panasonic BB-HGW700A Operating Instructions Manual

3.1.5

Using Camera

The camera page allows you to set up cameras connected to this product.
Usually it is not necessary to set up a camera because the automatic registration function of
Panasonic's Network Cameras sets up the camera name, port number, and IP address automatically.
When changing a camera name, follow the steps on page 42 - changing the setup of automatically
registered cameras. Also, when manually setting up a camera network, register cameras by following
the steps in additional camera registration.
Automatic Setup
Data Entry Field
Automatic Setup
IPv4 Camera
Available Address
Range
Port Number assigned
to network camera
Available Port Range
Select Enable or Disable.
Specify one sequenced address range to be allocated to the
camera.
• Be careful that it does not overlap the address allocated by a
server, such as a DHCP/PPTP server.
• The default is 192.168.0.151 - 192.168.0.166.
Select Single port or By range.
• If By range is selected, the value of the Available Port Range is
automatically allocated.
• Single port can be used in the following situations:
1 When connecting the WAN side to an internal company
network, without using address translation.
2 When using only the LAN without connecting to the WAN
side.
Specify the camera port number.
• When selecting By range above, it is only possible to specify one
sequenced port number range. It is necessary to have the same
number of port numbers as available address ranges specified
above, so specify the port number range that you will use.
• When selecting Single port above, specify one static port
number.
• The default is 60001-60016.
[For assistance, please call: 1-800-272-7033]
Operating Instructions
39