Speed Selector Switch; Main Switch (On/Off) - Panasonic EY7410 Operating Instructions Manual

the performance of the tool during
use or its battery capacity.
CAUTION:
• The built-in LED light is designed
to illuminate the small work area
temporarily.
• Do not use it as a substitute for a
regular flashlight, since it does not
have enough brightness.
• LED light turns off when the tool
has not been used for 5 minutes.
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.
 Bit-locking Function
With the switch at off and the bit lock-
ed in place, the tool can be used as a
manual screw-driver - up to 14.7 N·m
(150 kgf-cm, 130 in-lbs).
There will be a little play in the driving
shaft, but this is not a malfunction.
 Main Switch (ON/OFF)
Push the upper half of the switch for
forward rotation, or the lower half for
reverse rotation.
Forward
Reverse
 Speed Selector Switch
To suit the application of this tool, two
different rotational speeds are avail-
able. Depending upon use, either the
high or low speed should be selected.
HIGH
Speed selection
LOW
HIGH
CAUTION:
• Check speed selector switch before
use.
• Do not operate the speed selector
switch while the main switch is on
(switch is in the ON position).
 Main Switch Lock
After use, set the main switch lock at
the lock position to prevent accidental
operation.
Main switch lock
 Battery Pack
CAUTION:
1. Remove the battery pack away from
the tool.
- 7 -
Forward
Reverse
LOW
00 min (rpm)
-1
600 min (rpm)
-1
Torque
High
Low
Lock