Emergency Egress - Pioneer 500 ST Installation Manual

10. Emergency Egress

The Emergency Egress feature provides a simple and convenient means of exiting a Roll Seal RS- 500
Door from the inside of the structure should the door motor become inoperative due to a power failure or
other conditions.
INSTALLATION
Install the two Strap Retainers (1040-8400) to the inside of the top door jam and the left door jam as shown
below. For a wood framed door jams use two #10x1" screws (1004-1386). For a metal framed door jam
use two #8x1/2 Tek screws (1004-2492).
Install the Strap
Retainers on the
door jam
EXITING (OPENING) THE DOOR
When exiting the door, first pull the Emergency Strap from the retainers on the side of the door. See Step 1
below. Next pull down on the strap until the door stops. See Step 2. This will allow the doors to open
enough for a person to exit the structure.
Pull strap
away from
retainers to
center of door.
Part No. 4801-5154 Rev 4-08
3" from the
Left Track
6" above the
hanging position
of the handle
View from Door Jam Side
Pull strap
downward
until door
stops.
500 ST Door
Install the Strap
Retainers to the
top door jam and
the left side door
jam.
Page 18 of 25