Advertisement
c . . . . ____
I_n_st_8_II_in .... g_A_dd_i_ti_o_n_81_M_in_i-_F_lo_p .... P .... Y_D_iS_k_D_r_iV_8_S ____ )
The optional MZ-1 C30 cable is provided for connecting additional mini-floppy
disk drives.
Note:
The maximum number of disk drives which can be connected is 4.
1_ MZ-1 F19
1) Turn off the MZ-800 and its peripheral units.
2) Remove the screw on the left side of the additional disk drive and remove
the cover.
I.--\-- Jumper (set at the time
of
shipment)
Screw
3) Reset the DRIVE SELECT jumper on the circuit board according to the
• drive number. (The drive number is set to 1 at the time of shipment.)
Note:
The jumper setting pattern should be one of the 4 patterns on the next
page.
4) Replace the cover and screw it.
5) Remove the lower connector cover on the rear panel of the disk drive
which is already connected, and plug the connector with the name label
of the MZ-1 C30 cable into the lower connector.
Connect the other
connector of the cable to the upper connector of the additional disk drive.
Fasten both connectors of the cable with screws.
Follow the same procedures when the third and fourth disk drives are
connected.
-
6 -
Advertisement
