Advertisement
Cable attached to
First
Second
Third
Fourth
; ' MZ-'
E[BlfBtE ill
I~R"' ~',
of
<h.d,;w
MZ-1E05
MZ-1F19
MZ-1F19
MZ-1F19
MZ-1 F19
'~
,[!
'i
'[i
Position of the jumper -
~ ~ ~
2_
2 00
2 00
3 00
3_
3 00
4 00
4 00
4 00
4
Drive number
2
3
4
The drive numbers are as shown above. Stick the drive No. labels to the drives.
(The software uses these drive numbers to identify each drive.)
2_ MZ-1F02
Note:
The MZ-1 F02 must be used as the first and second disk drives.
1) Turn off the MZ-800 and its peripheral units.
2) Disconnect the cable from the MZ-1 F19.
3) Remove the screws on the left side of each disk drive unit to remove
:, the cover.
4) Set the DIP switch and jumper as shown on the next page.
Note:
Do not set the DIP switch and jumper to the position other than that shown
on the next page.
5) Remove the terminator set in the socket located above the DIP switch of
the MZ-1 F02.
Socket
DIP switch
-
7 -
Advertisement
