JVC GY-HM650U Instructions Manual page 123

9 Type
For setting the system to transfer videos for
distribution.
[Setting Values: RMPEG2-TS/UDP, MPEG2-TS/
TCP, RTSP/RTP, ZIXI]
Memo :
Use reception devices that are compatible with
0
the respective transfer systems.
To use the "ZIXI" setting, a dedicated server is
0
needed separately.
9 UDP/TCP Settings
For specifying the settings that are enabled only
when [Type] is set to "MPEG2-TS/UDP" or
"MPEG2-TS/TCP".
Memo :
The settings cannot be changed during live
0
streaming.
o Destination Address
For setting details such as the host name and the
IP address of the live distribution destination.
* Enter not more than 127 characters using single-
byte alphanumeric characters (a to z, 0 to 9),
single-byte hyphen [-], or dot [.].
o Destination Port
Enter the network port number of the live
distribution destination using an integer between 1
and 65535.
The default value is 6504.
9 RTSP/RTP Settings
For specifying the settings that are enabled only
when [Type] is set to "RTSP/RTP".
Memo :
The settings cannot be changed during live
0
streaming.
o Password
Changes the password for RTSP authentication to
enable client access. The current password is
displayed. Enter a new password directly.
There is no default value (blank).
* Enter not more than 31 characters.
9 ZIXI Settings
For specifying the settings that are enabled only
when [Type] is set to "ZIXI".
Memo :
The settings cannot be changed during live
0
streaming.
o Destination Address
For setting details such as the host name and the
IP address of the live distribution destination.
* Enter not more than 127 characters using single-
byte alphanumeric characters (a to z, 0 to 9),
single-byte hyphen [-], or dot [.].
o Destination Port
Enter the network port number of the live
distribution destination using an integer between 1
and 65535.
The default value is 2088.
o Stream ID
For setting the registered stream ID of the live
distribution destination.
The default value varies with the product model.
* Enter not more than 63 characters.
o Password
For setting the [Stream ID] password.
There is no default value (blank).
* Enter not more than 127 characters.
o Latency
For setting the latency mode.
[Setting Values: Medium, RLow]
Connection Setup
For configuring the network connection settings.
Configure the settings by following the instructions
on the [Wizard] screen that is displayed according
to the type of adapter that is connected to the rear
[HOST] terminal.
You can store (Store), load (Load), or delete
(Delete) the settings you have specified on the
[Wizard] screen.
9 Wizard
A [Wizard] screen appears according to the type of
adapter that is connected to the rear [HOST]
terminal.
Follow the instructions.
9 Load
Loads the settings on the [Wizard] screen.
(A P170 [Reading the Connection Settings
File] )
9 Store
Saves the settings on the [Wizard] screen.
(A P169 [Saving the Connection Settings File] )
9 Delete
Deletes the saved settings.
(A P171 [Deleting Connection Settings] )
123