Connection; Connection Of The Interface Board And Camera Unit - Panasonic GP-MH310 series Technical Manual

Connection

[1] Connection of the Interface Board and Camera Unit

Connect the camera unit and the interface board using the FFC (flexible flat cable) or thin line coaxial cable.
Connect the various terminals of the interface board using the necessary cables.
RS232C wire connection
switch (Straight or Cross).
HDMI
PC RS232C
PC USB
Switch for HDMI resolution. See below or
the sticker for the setting.
SW 3
1080p 30 OFF OFF OFF
1080i 60 OFF OFF ON
720p 60 OFF ON OFF
1080p 25 ON OFF OFF
1008i 50 ON OFF ON
720p 50 ON
NOTE
1. Component / Composite / HDMI out are mutually exclusive.
2. PC connection can be done with RS232C or USB(switch S2001).Please use commercially available USB cable for USB connection.
3. When using thin-line-coaxial-cable, physically disconnect the FFC, otherwise UART command connection will not work properly.
4. Download the USB driver for PC from below URL(Operating System: Windows2000/ WindowsXP,
DeviceName : FT232R).
( http://www.ftdichip.com/Drivers/VCP.htm )
5.The LVDS serial signal output from the HD module is created by the IC from National Semiconductor, DS92LV16.
To de-serialize the signal, the same IC could be used as a deserializer. Refer to: http://www.national.com/profile/snip.cgi/openDS=DS92LV16
To check HDMI-out, please
connect "thin-coaxial-cable" from
the module. Thin-coaxial-cable
is supplied separately, if not
included in the sample unit.
Composite / Component
use
HDMI use
C N 101
S 3501
S 2001
S 2002
C N 202 C N 203
C N 201
2 1
ON OFF
C N 102 C N 103
C N 204 C N 205 C N 206 C N 207
C N 208
Switch to select the
connection to PC(USB or
RS232C).
−3−
For composite/component use.
Insert the supplied FFC
below.
For Trigger-IN/Strobe-OUT
use.
Insert the supplied 3 pin
cable as below and connect
t o the module unit.
T P T P T P
101 102 103
Test pins.
TP101 STROBE OUT
TP102 TRIGGER IN
TP103 GND
(STROBE OUT is enabled
only One shot mode
of UVC )
Component
Composite
cable as