Panasonic KX-TAW848 Installation Manual page 124

4.1 Troubleshooting
List of Errors and Solutions
The tables below list the errors and their solutions.
When an error whose error code is indicated with "*" occurs in the PBX, the ALARM indicator
on the front of the cabinet turns on red, and the system logs the error information.
When the error conditions indicated by the error codes "021", "091", "092", and "510" are
recovered, the ALARM indicator will turn off automatically, indicating successful
troubleshooting. When other errors are logged, the ALARM indicator will turn off only when the
log for major or minor errors is cleared from the KX-TAW848 Maintenance Console.
In other words, the ALARM indicator will turn off under the following conditions:
When the errors "021", "091", "092", and "510" are logged: when the error
•
conditions are recovered
When other errors are logged: when the log for major or minor errors is cleared from
•
the KX-TAW848 Maintenance Console
Optional Service Card Initial Self Diagnosis
Error Error Message
Code
212 Echo canceller
access error
216 MSG card DSP
error
217 MSG card data
error
System Start-up and On-line Operation
Error Error Message
Code
000* MPR WDT
overflow
001 SDRAM bit error
124 Installation Manual
PROBABLE CAUSE
• Optional service card
malfunction: ECHO
• Optional service card
malfunction: MSG
• Optional service card
malfunction: MSG
• Erroneous recording of
messages
PROBABLE CAUSE
• Main Board (MPR)
malfunction
• Erroneous processing
of Main Board (MPR)
software
• Software error due to
external factors
SOLUTION
• See if the corresponding optional
service card is installed properly
• Pull out and re-insert the corresponding
optional service card
• Press the Reset Button
• Replace the corresponding optional
service card
• See if the corresponding optional
service card is installed properly
• Pull out and re-insert the corresponding
optional service card
• Press the Reset Button
• Re-record the messages
• Replace the corresponding optional
service card
SOLUTION
• Press the Reset Button
• Reprogram the PBX
• Replace the Main Board (be sure to
turn off the PBX when replacing)