Motion Detection - D-Link DCS-5020L User Manual

Section 4 - Configuration
This option allows you to set up Motion Detection on your network camera.
Enable Video Check this box to enable the motion detection feature of your
Motion: camera.
Enable PIR: When this option is selected, use PIR (passive infrared) to detect
motion. PIR is best suited for detecting motion from live
subjects such as people and animals.
Sensitivity: This setting adjusts how sensitive the camera will be to motion,
where 100% will be the most sensitive setting and 0% will be the
least sensitive setting.
Drawing Mode: Select Draw Motion Area to select the area of the picture to
monitor for movement to trigger recording or snapshot. Use your
mouse to click on the blocks that you would like to monitor for
motion. Select Erase Motion Area to remove the blocks and stop
the camera from monitoring that area of the picture.
Clear:
Clicking this button will clear all motion detection zones.
After making any changes, click the Save Settings button to save your changes, or click
the Don't Save Settings button to discard your changes.
Note: If the camera is set to SXGA mode in Audio and Video, Motion Detection is disabled.
The red grid on the right indicates an area that has been selected for motion detection.
When motion is detected, the LIVE VIDEO page will display a blinking orange motion
video icon like the one below.
No Motion
The motion notification will continue to blink as long as motion is detected. If no
additional motion is detected, it will return to its original state after eight seconds.
D-Link DCS-5222L User Manual

Motion Detection

Motion
47