Yamaha 2000 YFM400FWA Service Manual page 17

Tool No.
Sheave spring compressor
90890-04134
This tool is needed when removing or
YM-04134
installing the secondary sheave
spring.
Sheave fixed block
90890-04135
This tool is needed when removing or
YM-04135
installing the secondary sheave
spring.
Flywheel puller
90890-01404
YM-01404
These tools are needed to remove the
rotor.
Damper rod holder (30 mm)
90890-01327
This tool is needed to loosen and
YM-01327
tighten the steering stem bearing
retainer.
Oil filter wrench
90890-01426
YU-38411
This tool is needed to loosen or tighten
the oil filter cartridge.
Ring nut wrench
90890-01430
This tool is needed to removing and
YM-38404
installing the middle driven shaft bear-
ing retainer.
Gear lash measurement tool
90890-01467
YM-01467
90890-01475
This tool is used to measure the gear
YM-01475
lash.
Sheave holder
90890-01701
This tool is needed to hold the primary
YU-01880
sheave when removing or installing
the sheave bolts.
Compression gauge set
Set
90890-03081
Adapter
YU-33223
Adapter
These tools are needed to measure
90890-04082
YU-33223-3
engine compression.
Tool name/How to use
1 - 8
SPECIAL TOOLS
Illustration
GEN
INFO