Sony WalkMan MZ-NH700 Operating Instructions Manual page 89

Symptom
The recorder does not
work or works poorly.
The display window
is not normal.
When using with the
AC power adaptor,
the display window of
the recorder will
remain faintly lit for
some time even after
the recorder is
stopped.
The operation mode
of the blank 60/74/
80-minute standard
disc differs from the
mode following
formatting or the
mode selected in the
SonicStage software.
Titles (enterd on the
computer) with
Chinese characters
are not displayed
correctly in the
display window of the
remote control.
Cause/Remedy
• The HOLD function is turned on ("HOLD" appears in the display
when you press an operation button on the recorder).
, On the recorder, disable HOLD by sliding the HOLD switch to
the opposite direction of the arrow
• The lid is not firmly closed.
, Close the lid until it clicks. Then slide OPEN to open the lid.
• Moisture has condensed inside the recorder.
, Take the disc out and leave the recorder in a warm place for
several hours until the moisture evaporates.
• The AC power adaptor is not firmly connected.
, Connect the AC power adaptor firmly to the DC IN 3V jack on
the recorder.
• The rechargeable battery or dry battery is weak ("LOW BATTERY"
flashes or nothing appears).
, Charge the rechargeable battery, replace the dry battery with a
new one, or use the supplied AC power adaptor.
• The disc is damaged or does not contain proper recording or editing data.
, Reinsert the disc. Rerecord the disc. If the error message still
appears, replace it with another disc.
• There is a built-in malfunction in the system.
• While operating, the recorder received a mechanical shock, too much
static, abnormal power voltage caused by lightning, etc.
, Restart the operation as follows.
1 Disconnect all the power sources and the dedicated USB
cable.
2 Leave the recorder for about 30 seconds.
3 Connect the power source.
• The recorder was disconnected from the power source.
, Let the recorder sit for a while, or disconnect the power source,
reconnect it, and then press any of the operation buttons.
• This is due to the MiniDisc system limitation. The recorder turns off
3 minutes after the recorder has stopped in order to allow the
charging time to be calculated.
• When using a blank 60/74/80-minute standard disc in the recorder,
the operation mode set in the "Disc Mode" menu is applied.
, Use the "Disc Mode" menu to change the operation mode as
desired.
The recorder can display Chinese characters in titles that have been
transferred in Hi-MD mode. Chinese characters transferred in MD
mode cannot be displayed.
.
(pages 12, 16)
89