Setting Up The Base Unit; Preparing The Battery Pack - Sony SPP-A941 Service Manual

Step 2

Setting up the base unit

Do the following steps:
• Choose the best location
• Connect the base unit
• Choose the dialing mode
Choose the best location
Where you place the base unit affects the reception quality of the
handset.
Away from television
sets and other
electronic equipment
Near a central location
and on a level surface
CAUTION: • Should you experience intermittent loss of audio during a conversation, try
moving closer to the base or move base unit away from other noise sources.
• The cordless telephone operates at a frequency that may cause interference to
nearby TVs and VCRs; the base unit should not be placed near or on the top of
a TV or VCR; and, if interference is experienced, moving the cordless telephone
farther away from the TV or VCR will often reduce or eliminate the
interference.
8 US
Getting Started
Step 2: Setting up the base unit (continued)
Notes
• Use only the supplied AC-T130 AC power adaptor.
Do not use any other AC power adaptor.
• Connect the AC power adaptor to a continuous power
supply.
• Place the base unit close to the AC outlet so that you
can unplug the AC power adaptor easily.
Tip
If your telephone outlet is not modular, contact your
telephone service company for assistance.
10 US
Getting Started
Away from noise sources such as a window
by a street with heavy traffic
Away from heat sources, such as radiators,
airducts, and sunlight
Away from a microwave
oven
Away from excessive
moisture, extremely low
temperatures, dust,
mechanical vibration, or
shock
Away from a personal
computer
Away from another
cordless telephone
Polarity of the plug
–
+
Modular
Connect the base unit
If you want to hang the base unit on the wall, see page 37.
Hook the cord.
To an AC outlet
2
AC power adaptor
(supplied AC-T130)
1
Telephone line cord
(supplied)
To the
telephone outlet
Step 3

Preparing the battery pack

Charge the battery pack for more than 10 hours before you start using
your phone.
BP-T23
CHARGE lamp
– 4 –
3
To DC IN 9V
To LINE
1
Connect the telephone line cord
to the LINE jack and to a
telephone outlet.
2
Connect the AC power adaptor
to the DC IN 9V jack and to an
AC outlet.
3
Raise the antenna. Make sure it
points towards the ceiling.
Getting Started
1
Slide open the battery
compartment lid of the handset.
2
Insert the battery pack (with
contacts facing down) into the
battery compartment.
3
Close the battery compartment
lid.
4
Place the handset on the base
unit.
The CHARGE lamp lights up
when the handset is properly
seated on the charge terminals
of the base unit. Charge the
battery pack for more than 10
hours so that the battery is fully
charged. The CHARGE lamp
remains lit even after charging
is completed.
Getting Started
continued
US
9
continued
11 US