Telephone Features - Sony SPP-A941 Service Manual

Telephone Features

Speed dialing
You can dial with a touch of a few buttons by storing a phone number
on a dialing button. You can store up to 10 different phone numbers.
Storing phone numbers
1
2
3
TALK/
BATT LOW
lamp
(REDIAL/PAUSE)
4
Notes
• In step 3, if you don't enter the phone number, the previously stored number
will be erased.
• Do not allow more than 30 seconds to elapse between each step of the
procedure.
• Before storing phone numbers, make sure the handset is not in use.
Tips
• If you enter a wrong number, start from the beginning.
• Use the supplied directory to write down what you stored on the speed
dialing numbers.
Setting the ringer type
You can select a ringer type from four types.
1
2
3
4
Turning off the ringer
1
Press (PGM).
2
Press (#).
3
Press (5).
4
Press (SPEED DIAL).
The ringer on the handset is turned off.
To turn the ringer on again
Follow the instructions described in "Setting the ringer type."
Checking the ringer type
1
Press (PGM).
2
Press (#).
3
Press (0).
The currently selected ringer sounds.
4
Press (SPEED DIAL).
Note
If you hear no sound (only key beep), the ringer on the handset has been turned
off.
Press (PGM).
The TALK/BATT LOW lamp flashes.
Press one of the dialing buttons ((0)
to (9)) for the phone number to be
stored.
Enter the phone number you want to
store.
You can enter up to 16 digits,
including a tone and a pause, each of
which is counted as one digit.
Press (SPEED DIAL).
You'll hear a confirmation beep, and
the number is stored. The TALK/
BATT LOW lamp goes off.
continued
Telephone Features
Press (PGM).
Press (#).
Press a number button, (1) to (4), to
select a ringer type.
Press (SPEED DIAL).
continued
Telephone Features
Speed dialing (continued)
To store the previous number dialed
Press (REDIAL/PAUSE) directly after step 2, then go to step 4.
To store a number to be dialed via Private Branch Exchange (PBX)
Before entering a phone number in step 3 on page 19, do as follows:
1
Enter the outside line access digit (e.g. 9).
2
Press (REDIAL/PAUSE).
To change a stored number
To store a new number, follow the instructions described previously.
Making calls with speed dialing
1
Press (TALK/FLASH).
The TALK/BATT LOW lamp lights up.
2
Press (SPEED DIAL).
3
Enter the desired speed dialing number ((0) to (9)).
The phone number stored in the speed dialing number will be dialed.
19 US 20 US
Telephone Features
Setting the ringer type (continued)
Setting the base ringer
Note
The base ringer is preset to on.
US
22
21 US Telephone Features
– 6 –
1
Press (MENU) until you hear
"Set base ringer".
"- -" blinks on the display.
2
Press (SELECT) to turn the
ringer on or off.
3
Press (TIME/SET).
The base ringer setting is
announced.
4
Press (PLAY/STOP) to exit the
menu set up mode.