Panasonic HX-A1M Basic Owner's Manual page 22

4
Fasten the Multi Mount securely by aligning the two
fasteners to one another.
≥ Fasten securely to prevent the Multi Mount from falling off.
≥ Dust, etc. adhering to the hook and loop fastener will weaken the
adhesion. Before attaching it, check if dust, lint, etc. is adhering.
5
Attach this unit to the Multi Mount as shown in the
figure. (l 23)
≥ When removing the Multi Mount, do not pull the Multi Mount. Remove it by peeling off the hook
and loop fastener from the edge.
≥ Do not peel off the double sided tape attached to the hook and loop fastener. Once the tape is
peeled off, the adhesion weakens, making the tape unusable.
≥ When attaching the Multi Mount, check if the hook and loop fastener is fastened securely and the
adhesion of the double sided tape has weakened.
Attaching to the shoulder strap of a backpack, etc.
≥ Before attaching the Multi Mount, remove the hook and loop fastener from the Multi Mount.
1
Tuck a shoulder strap of a backpack or
similar item between the Multi Mount
and the band, and pass the band
through the portion A to hold the Multi
Mount in position.
≥ Before attaching the Multi Mount, check that the
hook and loop fastener side of the band is facing up.
≥ Move the Multi Mount to the position where you
want to attach it.
2
Pass the band through the ring B as shown in the
figure.
3
Fold the band inwards as shown in the figure, and
fasten it with the hook and loop fastener C of the
band.
22
SQT0885 (ENG)


