Epson STYLUS PRO 7450 Unpacking & Setup Instructions page 16

2. Assemble the left leg and left base in the same
way as step 1.
3. Insert the bottom horizontal strut into the
right and left bases as shown. Use the hex
wrench (G) to fasten the strut with collars (K)
and strut bolts (I).
Note:
After assembling the bases and bottom horizontal
strut, make sure that they are fastened tightly.
K
I
4. Insert the top horizontal strut into the right
and left legs. Use a screw driver to fasten the
strut with hex socket head bolts with washers
(J).
J
J
14
5. This completes assembly of the Stand. Make
sure each part of the Stand is tightened
securely.
Mounting the printer on the Stand
c
Caution:
Two or more people are required to mount the
printer. Hold the printer at the indicated
locations as shown. If the ink cartridges are
installed, do not tip the printer at an angle.
Otherwise, ink may leak from the cartridges.
1. Lock the two casters and extend the two
stabilizer knobs underneath the base unit.
Note:
Place the casters sideways and lock them so they
will not move.
K
I
2. Mount the printer on the printer mount as
shown.
J