Installing The Ink Cartridges - Epson STYLUS PRO 7450 Unpacking & Setup Instructions

3. Route the power cord through the clamps at
the rear of the printer. The cord can be routed
to either the left or right side.
4. Plug the power cord into a properly grounded
electrical outlet.
c
Caution:
Do not use an outlet that is controlled by an
automatic timer or wall switch. Otherwise,
accidental shut down or damage to your
printer may occur.

Installing the Ink Cartridges

To install the ink cartridges, follow the
instructions below.
w
Warnings:
The ink cartridges are self-contained units.
Under ordinary use, ink will not leak from the
cartridges. If ink does get on your hands, wash
them thoroughly with soap and water. If ink gets
into your eyes, flush them immediately with
water.
Note:
❏ The ink cartridges packaged with your printer are
partly used during the initial setup. In order to
produce high-quality prints, the print head in your
printer will be fully charged with ink. This one-off
process consumes a quantity of ink and therefore
these cartridges print fewer pages compared to
subsequent ink cartridges.
❏ Initial ink charging requires approximately
10 minutes.
❏ Each slot can hold a particular color of ink. Be sure
to install the ink cartridges in the correct slots
according to the ink mode you choose.
1 2 3 4
No. EPSON Stylus Pro
9880/9880C/7880/7880C
#1 Light Light Black
#2 Vivid Light Magenta
#3 Light Cyan
#4 Light Black
#5 Matte Black or
Photo Black
#6 Cyan
#7 Vivid Magenta
#8 Yellow
5 6 7 8
EPSON Stylus Pro
9450/7450
Matte Black
Matte Black
Magenta
Magenta
Cyan
Cyan
Yellow
Yellow
17