Connect To The Storage System; Power On The Server And Log On - HP StoreEasy 1000 Administrator's Manual

6. Connection from the P822 controller to port 2 of I/O module A on the top D2600 in Group 2
7. Connection from the P822 controller to port 2 of I/O module B on the top D2600 in Group 2
8. SAS daisy chain – port 1 of I/O module B on the top D2600 connects to port 2 of I/O module B on the bottom
D2600 and port 1 of I/O module A on the top D2600 connects to port 2 of I/O module A on the bottom D2600

Connect to the storage system

Use either the direct attach or remote management method to connect to the storage system.
IMPORTANT:
install the storage system. After the storage system installation process is complete and the server's
IP addresses have been assigned, you can then additionally use the remote desktop method to
access the storage system.
Direct attach —This access method is mandatory if your network does not have a Dynamic
Host Configuration Protocol (DHCP) server. Connect the following cables to the back panel
of the storage system in the following sequence: keyboard, mouse, network cables, monitor
cable, and power cable.
NOTE:
Remote management—Access the storage system using the Integrated Lights-Out (iLO) remote
management method:
1. Connect the desired network cables to network adapter ports on the back of the storage
system.
2. Connect a network cable to the iLO port located on the back of the storage system.
3. Connect a power cable to the storage system.
4. Locate the iLO Network Settings tag attached to the storage system and record the default
user name, password, and DNS name.
5. From a remote computer, open a standard Web browser and enter the iLO management
hostname of the storage system.
NOTE:
network's DHCP server. The hostname found on the iLO tag is automatically registered
with your network's DNS server.
6. Using the default user information provided on the iLO Network Settings tag, log on to
iLO, and then launch a remote console to the storage system.
For detailed instructions on using iLO remote management software, see the HP iLO 4
User Guide.

Power on the server and log on

1. Power on the system by pushing the power button on the front panel. If using iLO, click
Momentary Press under the Power Switch menu of the remote console.
The storage system starts and displays the Setup Windows wizard, in which you select language
and regional settings and accept the license agreement. The storage system installation process
takes approximately 10–15 minutes.
2. When the storage system installation process nears completion, the Windows Storage Server
2012 Standard Edition desktop displays the following message: The user's password must
be changed before logging on the first time. Log on to the storage system by establishing an
Administrator password:
a. Click OK.
b. Enter the Administrator password in the New password box.
Only the direct attach and remote management access methods can be used to
The keyboard, mouse, and monitor are not provided with the storage system.
By default, iLO obtains the management IP address and subnet mask from your
Connect to the storage system 37