NEC EXPRESS5800 LC1400 series User Manual page 102

8. Holding the board by its top edge or upper corners, firmly press the board
into an expansion slot on the system board. The tapered foot of the option
board retaining bracket must fit into the mating hole in the expansion slot .
9. Align the rounded notch in the option board retaining bracket with the
alignment tab in the expansion slot frame. The retaining bracket fits into the
space that was occupied by the expansion slot cover.
10. Be sure to push the bracket slot up against the expansion slot frame. If this is
not done, the bracket may interfere with an adjacent bracket.
11. Install the previously removed expansion slot retainer bar by pressing its top
fastener into the top of the expansion slot frame. The bottom tapered tab of
the expansion slot retainer bar fits into the mating slot on the bottom of the
expansion slot frame.
12. Connect any external cables (if they are needed) to the installed option
board.
13. Replace the left side panel; plug in the system power cord, and power on the
system.
4-22 Upgrading Your System
Installing an Option Board